Vernier LabPro User Manual Page 17

  • Download
  • Add to my manuals
  • Print
  • Page
    / 35
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 16
Vernier LabPro User’s Manual 13
Tutorial: Temperature Measurement with EasyData
A good way to get acquainted with LabPro is by performing a simple experiment. Using this tutorial,
you will take measurements using a Temperature Probe. Just follow the simple steps, and you are well
on your way to collecting and analyzing data with a calculator.
MATERIALS
TI graphing calculator
LabPro interface
Vernier Stainless Steel Temperature Probe
One 250 mL beaker or cup
100 mL hot water
PROCEDURE
1. Place about 100 mL of hot water into a 250 mL beaker or a cup.
2. Plug the Stainless Steel Temperature Probe into CH 1 on LabPro, and place the Temperature Probe
on the tabletop.
3. Start the EasyData application. EasyData will detect the auto-ID sensor, set the data collection
parameters, and display the current sensor reading. The experiment will collect temperature for 180
seconds.
4. Select
to begin data collection.
5. Wait about 10 seconds and place the Temperature Sensor into the cup of hot water as shown above.
A live graph will appear on the calculator screen. You can either allow EasyData to complete data
collection or press
to stop data collection.
6. After the data collection is complete, an autoscaled graph of the data will appear. Notice that the
probe does not read the new temperature instantly; it takes a little while to respond. This is a
characteristic of the sensor. Use the
or keys to examine the data points along the
displayed curve of temperature vs. time. As you move the cursor right or left, the time (X) and
temperature (Y) values of each data point are displayed below the graph. Move the cursor to the
point when the probe was first placed in the hot water. Record that time. Move the cursor to find the
highest temperature and record that time. How long did it take for the temperature sensor to stabilize
at the water’s temperature?
Page view 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 34 35

Comments to this Manuals

No comments